View Single Post
Old August 11, 2012, 11:08 PM   #1
mwurdeman07
Junior Member
 
Join Date: August 11, 2012
Posts: 7
Please help before I end up blowing up myself or my gun!

Hi guys so I have recently acquired some reloading equipment. The Lee turret press along with pro auto disk powder measure and the dies with the factory crimp. I set up the turret according to instructions and even referenced a few knowledgeable youtube videos.

Here is my setup:

Smith and Wesson m&p9
-Brass found on the ground at my range which has been tumbled in media.
-Hodgdon h-6 powder (4.7gr per load)
-9mm 124 gr plated bullets ( http://www.shop.rmrbullets.com/produ...&categoryId=12) to be exact
-Federal small pistol primers
-and finally my OAL 1.125

I just chronoed my first shot at 4500 fps! Needles to say I did not fire any more of that load. The chrono was correct as I tested factory loaded ammo at 1100fps. Also my reloads do not eject.

I think it may be my OAL that is the issue, what do you guys think? Please help, I really dont want to blow up my gun or myself!

Last edited by mwurdeman07; August 11, 2012 at 11:56 PM.
mwurdeman07 is offline  
 
Page generated in 0.02835 seconds with 8 queries