View Single Post
Old November 29, 2012, 02:29 PM   #8
Doc Hoy
Senior Member
 
Join Date: October 24, 2008
Location: Naples, Fl
Posts: 5,440
Thanks Hardcase

I think the stock was repaired previously by just gluing the broken piece back onto the bottom of the stock. It is very sturdy and although the crack seems to go all the way through the piece does not budge when I pry on it. I thought about routing a channel into the stock and then gluing a walnut slat into the channel and sanding it down. I waited on that evolution until aftger I finished the stock to see just how obvious the new wood is.

I finished it with teak oil and it turns out the match is quite good.

I may try the repair using a walnut slat.
__________________
Seek truth. Relax. Take a breath.
Doc Hoy is offline  
 
Page generated in 0.03467 seconds with 8 queries