View Single Post
Old October 20, 2012, 10:40 AM   #19
Brian Pfleuger
Moderator Emeritus
Join Date: June 25, 2008
Location: Austin, CO
Posts: 19,339
Originally Posted by coyota1 View Post
I don't know if Remington does this but some barrels have a very slight constriction "choke" at towards the end of the barrel. I can look this up in my material to get more info on this. That's what would stop me from shortening a barrel until I knew how it was constructed.
No reputable gun maker does that on purpose. Good barrels are held to very tight tolerances, end to end. Down to .0001" end to end variance.

If anybody does, I've never heard of it. Most companies brag about the exact OPPOSITE.
Brian Pfleuger is offline  
Page generated in 0.03195 seconds with 8 queries