View Single Post
Old June 16, 2000, 06:59 PM   #4
James E
Junior member
 
Join Date: April 20, 2000
Posts: 371
I'm using a lyman 500, works for me. Redding is an excellent brand you can't go wrong there. On the powder measure...check out the Hornady one but add a Case Activated Powder Drop. This device holds the powder measure and screws into your press die hole. And if you are lucky the press will accept Hornady's Lock-N-Load insert. (Twist dies or powder measure in...twist to take out) I had my old Pacific tool 07 press bored and threaded to accept the L-N-L. When the powder measure is in position run a cartridge up into the CAPD Hornady unit...and you get powder in your brass. Great!

Jim
James E is offline  
 
Page generated in 0.02328 seconds with 8 queries