[thibaultfelix40]

You can make a dovetail blank with a file from a piece of 1/8x1/2 flat steel, cut it off with a hack saw. Once you get it so it fits snug in the slot drill and tap it for #8-32 nylon screw. Put the dove tail in the slot. Cold blue a 8-32 galvanizsd nut. Screw the nut on an 1" 8-32 nylon bolt. Squirt the hole in the dove tail full of Locktite. Screw the bolt into the dove tail. Put a little more Loctite on and tighten down the nut. The screw and nut should be snug but not tight as......... You will now have a nylon bolt sticking up from the end of the barrel with a little stanchion formed by the nut. Go to the range with a sharp knife. When you get through you will have a white post. If you dont like white, you can use brass or blued sreel which you can paint.