View Single Post
Old September 4, 2017, 01:44 PM   #11
mehavey
Senior Member
 
Join Date: June 17, 2010
Location: Virginia
Posts: 6,390
Quote:
I went out this morning; pulled the gun apart; put a folded-in-half/spiraled sheet of
320-then-400 into my usual spit 3/8" dowel trick.... and ran two 90-sec sessions
each into the chamber using a cordless drill and cutting oil.

Going out to the range now w/ ElCheapoGrande brand now....
Back....

"Improved" Ran a combined box-worth of the Cheapos mentioned above.

Only had two that required table banging; Most shucked reasonably cleanly; and a half-dozen req'd I push the slide forward before it would release/back cleanly.

Came back and did it again starting with 220 through 600grit
The thing's a doggoned mirror.

Film at Six.....
mehavey is online now  
 
Page generated in 0.02991 seconds with 8 queries