The Firing Line Forums - View Single Post

shuppr · November 6, 2009, 11:32 AM

I am fairly new to reloading have been buying bullets at various places however have only reloaded one caliber so far that is 30 Carbine 110grn jacketed bullet using H110 14 grains works very well. Also Lead 115 grain using H110 at 12grns again works well. I am in the beginning stages of casting my own bullets but do not have a sizer/lubricater the molds I have are

Lee 2-Cavity Bullet Mold 358-158-RF 38 Special, 357 Magnum, 38 Colt New Police (358 Diameter) 158 Grain Flat Nose

Lee 2-Cavity Bullet Mold 401-175-TC 40 S&W (401 Diameter) 175 Grain Truncated Cone
I have searched all the forums read the Lee manual read Lyman 49th edition So my question is Can I pan lube these bullets made from these Molds and if so what lube would be recommended.

Thanks

November 6, 2009, 11:32 AM	#1
shuppr Junior Member Join Date: November 6, 2009 Location: Southern Indiana Posts: 4	Lubing Cast bullets I am fairly new to reloading have been buying bullets at various places however have only reloaded one caliber so far that is 30 Carbine 110grn jacketed bullet using H110 14 grains works very well. Also Lead 115 grain using H110 at 12grns again works well. I am in the beginning stages of casting my own bullets but do not have a sizer/lubricater the molds I have are Lee 2-Cavity Bullet Mold 358-158-RF 38 Special, 357 Magnum, 38 Colt New Police (358 Diameter) 158 Grain Flat Nose Lee 2-Cavity Bullet Mold 401-175-TC 40 S&W (401 Diameter) 175 Grain Truncated Cone I have searched all the forums read the Lee manual read Lyman 49th edition So my question is Can I pan lube these bullets made from these Molds and if so what lube would be recommended. Thanks