View Single Post
Old February 6, 2013, 09:36 PM   #7
AR15barrels
Member
 
Join Date: August 23, 2006
Location: Los Angeles, CA
Posts: 53
Almost all of the suppressor makers have published thread specs that call out a clearance cut behind the thread tendon so that you end up with a nice square shoulder to seat Thea direct mount can against.
on the cans that use a mount on the barrel, the mount will generally come with shims and rocksett.
The better muzzle devices and cans will have a counterbore in the threads to account for the lack of threads on typical factory barrels such as your bravo company barrel.

When I thread barrels, I have a nice clearance cut behind the thread tennon.

AR15barrels is offline  
 
Page generated in 0.03228 seconds with 8 queries