View Single Post
Old November 27, 2019, 11:55 AM   #13
kmw1954
Senior Member
 
Join Date: June 11, 2016
Location: SE Wisconsin
Posts: 1,365
BBarn that was my original thinking also though I cannot prove it one way or the other. Brass used was all sorted headstamp. When working up loads I try to stay as consistent as possible. Weigh every powder charge and measure every round before it goes in the box. And in the case of these cast bullets I was plunk testing every round in both barrels. Then I guess I got sloppy and the second session just weighed and measured as the press was still set up from the previous session and the only change was the bullet. From the sample casts I received to the ones I cast myself.

But still that does not explain why the longer seated bullet will now reliably seat whereas the others would hit the rifling.
kmw1954 is offline  
 
Page generated in 0.02663 seconds with 8 queries