Thread: S&W .38 Mod 10
View Single Post
Old July 15, 2021, 07:05 AM   #10
4V50 Gary
Staff
 
Join Date: November 2, 1998
Location: Colorado
Posts: 21,199
Oh gawd! I had an old victory model and had to make a new cylinder center pin. The original was JB Welded up to length and so a new one had to be turned on the lathe. I learned that when I went to file the top to smooth it out. Too much came off with one pass of a fine tooth file.

Good luck in getting that longer ejector rod. Keep shopping.
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe!
4V50 Gary is offline  
 
Page generated in 0.04052 seconds with 8 queries