Thread: S&W .38 Mod 10
View Single Post
Old June 21, 2021, 12:19 PM   #4
Clemson
Senior Member
 
Join Date: March 9, 2001
Location: Greenwood, SC
Posts: 860
I bought two of them. I was able to fit a 2" Numrich barrel to one, but they have since run out of those barrels. I put a 4" on the other, and as was noted by a previous poster, changed out the center pin and ejector rod. Both made up into sound, mechanically good revolvers. They are not cosmetically anything to write home about. There is heavy stamping on the bottom of the frame in front of the guard from the agency that used them in (I think) South America. Use a proper frame wrench (and not a hammer handle through the frame window) to tighten up the barrel.

Bill Jacobs
__________________
NRA Endowment Member, NRA Certified Instructor
CWP Holder
US Army veteran
Gunsmith www.boltandbarrel.com
Clemson is offline  
 
Page generated in 0.03579 seconds with 8 queries