The Firing Line Forums - View Single Post

arch308 · April 25, 2013, 04:32 PM

I really don't think it's my reloads because all my other 45s (Kimber, G21, Colt Combat Commander, Ruger SR1911. Ruger P95) run them without a hitch. I also have a hard time believing that the mags are the problem as they are both fairly new factory mags, but I will try with a Wilson Combat and Ruger mag soon.
The tight chamber suggestion sounds very reasonable. I have expierenced that with my Ruger BH cylinder. But why would the tip of the bullet be marked up? Also I neglected to mention that one of the rounds that I cleared had an obvious nick in the base that I assumed was caused by the extractor. Hmmmmmm...

April 25, 2013, 04:32 PM	#10
arch308 Senior Member Join Date: November 6, 2011 Location: DFW, Texas Posts: 876	I really don't think it's my reloads because all my other 45s (Kimber, G21, Colt Combat Commander, Ruger SR1911. Ruger P95) run them without a hitch. I also have a hard time believing that the mags are the problem as they are both fairly new factory mags, but I will try with a Wilson Combat and Ruger mag soon. The tight chamber suggestion sounds very reasonable. I have expierenced that with my Ruger BH cylinder. But why would the tip of the bullet be marked up? Also I neglected to mention that one of the rounds that I cleared had an obvious nick in the base that I assumed was caused by the extractor. Hmmmmmm...