View Single Post
Old February 22, 2014, 04:17 PM   #1
fallingrock71
Senior Member
 
Join Date: October 25, 2008
Location: OK
Posts: 109
New Kahr CM9 shooting low.

Please pardon the laziness. I'm in no mood for searching.

Took my brand new CM9 to the range last week and ran about 150rds through it.

The good...Functioned absolutely flawlessly with wwb, umc, herters, critical duty +p, monarch +p, and some Underwood. I liked the trigger. Not as good as my SR9c, but very good. Recoil wasn't bad at all. It didn't hurt any part of my big ole hands like some tiny little pistols do. Follow up shots were very quick. It shot some pretty good groups.

The bad and frustrating...It shoots about 6 inches low at 25 feet. I found that at that distance if I aligned the rear sight on the front of the slide(below the front sight) it was pretty much to point of aim. I finally put it away because it was bugging me a LOT more than it should have. That and I was having entirely too much fun with my other guns.

Again, sorry for the laziness and probably dumb question but how to I fix it? I'd really like this one if it would just put them dang holes in the target where I put the sights ya know.
__________________
"I have sworn upon the altar of God eternal hostility against every form of tyranny over the mind of man."
~Thomas Jefferson
fallingrock71 is offline  
 
Page generated in 0.02236 seconds with 8 queries