The Firing Line Forums - View Single Post

Misssissippi Dave · September 25, 2012, 08:45 PM

Remington 9 mm ammo seemed to be a little light loaded to me. With a new pistol or new slide spring I have had some feed problems. After about 1000 rounds it would cycle even with those loads. I try to replace slide springs every 5000 rounds or so. My reloads will cycle just fine even with a new spring in my pistol.

I was having problems with 115 grain bullets hitting a little low unless I push them near the max loads. The 124 grain bullets hit just fine with this load using the factory sights. It isn't a max load. I believe it is a bit above mid-range. It has been tried in 10 different 9 mm pistols so far.

September 25, 2012, 08:45 PM	#10
Misssissippi Dave Senior Member Join Date: December 5, 2009 Posts: 1,411	Remington 9 mm ammo seemed to be a little light loaded to me. With a new pistol or new slide spring I have had some feed problems. After about 1000 rounds it would cycle even with those loads. I try to replace slide springs every 5000 rounds or so. My reloads will cycle just fine even with a new spring in my pistol. I was having problems with 115 grain bullets hitting a little low unless I push them near the max loads. The 124 grain bullets hit just fine with this load using the factory sights. It isn't a max load. I believe it is a bit above mid-range. It has been tried in 10 different 9 mm pistols so far.