|
The 670 has the push-feed action, and the extractor for those slides in a T-slot and is held in palce by a spring and a small ball. The inside edge of the extractor often gets rounded, or the extractor sticks in the slot and will not fully grip a case rim. Clean with solvent and a brush until you can get full range of motion for the extractor. If you decide to remove the extractor, be careful you do not launch the spring and detent ball.
Also, make sure the ejector is moving freely since this keeps pressure between the case rim and extractor. If the plunger is jammed or sticky, you can usually get it moving again if you scrub it out well.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
|