|
Sizing die
I am running a Lee Loadmaster for 9mm. Just going through the steps before I start dropping powder. Seems like I am pretty close. I had to back my sizing die to the point that it only goes about half the distance between the ejector groove and top of case. I am well within specs and the empty cases load and eject from my 1911 fine. I was kind of hoping for some hard numbers or more definite depths. I started off trying to run the die to the groove but abandoned that idea due to excessive force to get the die down. If the top diameters are correct is the case correct and die depth correct?
__________________
Concentrated power is not rendered harmless by the good intentions of those who create it.
Milton Freidman
"If you find yourself in a fair fight,,,
Your tactics suck"- Unknown
|