View Single Post
Old February 25, 2013, 09:08 PM   #3
RepentantMonkey
Junior Member
 
Join Date: June 25, 2007
Posts: 5
Sport45,

Sorry. I misstated the issue. It is with the LOAD DATA that came with the Lee dies, not the dies themselves.

I can up the load to a .37 on the auto disc but I always try to stay in the middle of the load ranges and that would put it right at the max.

And yes ... I measured the loads on a scale.

Accurate #2 said on the can that is is clean burning. 'low pressure' so maybe I will switch to #5 and see how those perform at the recommended loads for that powder.

Thanks!
RepentantMonkey is offline  
 
Page generated in 0.03937 seconds with 8 queries