View Single Post
Old February 21, 2008, 02:21 PM   #14
crobar
Member
 
Join Date: February 20, 2008
Location: N. Idaho
Posts: 23
Success

I removed the synthetic stock (per plateshooter) and the trigger assy just slid out as it is supposed to. There is a pin going thru the middle of the tang that extends out of the rear of the trigg assy where the trigger assy meets the butt stock. The pin had been installed with the pin to far out on one side and was causing the hang-up. A simple push on the pin to center it fixed the problem. My thanks to plateshooter and everyone else who were nice enough to share their ideas and thoughts. This is a great forum group.
crobar is offline  
 
Page generated in 0.03085 seconds with 8 queries