The Firing Line Forums - View Single Post - Garand trigger pin walking out with Dupage stock?

James K · March 22, 2018, 07:07 PM

Now I am confused. That pin should be held in place by the stock and the usual fix for the problem is to simply glue a small piece of walnut into the stock to keep the pin from drifting. In the worst case condition, the housing can be staked adjacent to the pin head, as was often done at the factory.

Jim

March 22, 2018, 07:07 PM	#7
James K Member In Memoriam Join Date: March 17, 1999 Posts: 24,383	Now I am confused. That pin should be held in place by the stock and the usual fix for the problem is to simply glue a small piece of walnut into the stock to keep the pin from drifting. In the worst case condition, the housing can be staked adjacent to the pin head, as was often done at the factory. Jim