The Firing Line Forums - View Single Post

AKexpat · April 16, 2019, 05:55 PM

That would be me. The Uberti cylinder dimensions were very close to the ASM cylinder dimensions, but new Uberti parts are CNC machined whereas the ASM [BC] 1993 gun was not CNC machined. Maybe a fluke that it fit, but it does, and the Uberti cylinder dimensions were .001"-.002" smaller than my ASM cylinder.

I have no clue as to where you can find stainless parts for an ASM. Maybe Fingers McGee will chime in.

Regards,

Jim

April 16, 2019, 05:55 PM	#17
AKexpat Senior Member Join Date: January 5, 2014 Location: SW WA State Posts: 490	That would be me. The Uberti cylinder dimensions were very close to the ASM cylinder dimensions, but new Uberti parts are CNC machined whereas the ASM [BC] 1993 gun was not CNC machined. Maybe a fluke that it fit, but it does, and the Uberti cylinder dimensions were .001"-.002" smaller than my ASM cylinder. I have no clue as to where you can find stainless parts for an ASM. Maybe Fingers McGee will chime in. Regards, Jim __________________ To be governed – is to be watched, inspected, directed, indoctrinated, numbered, estimated, regulated, commanded, controlled, law-driven, preached at, spied upon, censured, checked, valued, enrolled – by creatures who have neither the right, nor the wisdom, nor the virtue to do so. - Pierre-Joseph Proudhon Last edited by AKexpat; April 16, 2019 at 06:25 PM.