Thread
:
Screwing trunnions?
View Single Post
September 23, 2011, 03:31 PM
#
2
jaguarxk120
Senior Member
Join Date: February 28, 2008
Location: Michigan
Posts: 2,620
Riveting is for ease of manufacture.
Think about the tooling and extra labor required to drill/tap/install the screws. Insert rivets, place in press hit the cycle switch and your done.
The screws should work fine for what you want to do.
jaguarxk120
View Public Profile
Find More Posts by jaguarxk120
Page generated in
0.03081
seconds with
8
queries