View Single Post
Old August 8, 2013, 06:17 PM   #33
trecon
Junior Member
 
Join Date: July 23, 2013
Posts: 8
Quote:
On the other hand the 15 min trigger job I did myself, along with the pre-travel reduction via the Allen screw, both helped me attain a very predictable, crisp 3lb 11oz trigger at no additional cost.
gcp: I am troubled by your comment. 1st, 15 min. trigger job? 2nd, you mention Allen screw like it was separate from the trigger job? 3rd, this was "at no additional cost," i.e. the adjuster screw? Also, you mentioned further up the thread that the feel became "gritty." The original poster did not mention this RE his application of the adjuster screw. Am I to take this as being indicative of the trigger, or the user?
trecon is offline  
 
Page generated in 0.03217 seconds with 8 queries