Finally made it to the range yesterday to try out my gallery loads with TB. I had made several rounds at 8.5, 9.0, 9.5, and 10.0 grains each. The weather was nasty so I didn't setup the chrono; I really just wanted to check felt recoil and accuracy.
I used a Berry plated 110 grain round nose seated to a COL of 2.480 with a medium crimp. Cases were trimmed to 2.030. Shooting at 25 yards, the 9.0 grain load grouped the best. Very light recoil and shooting to point of aim.
I did get several failure to fire rounds. Recocked the hammer, and they fired the second try. I checked those fired cases in a case length gage, and they fit fine. I also had a couple that I could not close the action on. Again, checking those rounds in a case length gage showed no problems.
Any ideas why that would happen?
|