View Single Post
Old June 17, 2007, 03:11 PM   #12
jclayto
Senior Member
 
Join Date: February 14, 2005
Location: Anderson, SC
Posts: 600
I may try your method of not using the indexing for now. i went out yesterday and was gentle with my movements and that seemed to be working ok but as the day progressed it started acting up again, sometimes not turning at all, other times only turning 1/2 turn or so.

I was able to get the decapper adjusted and working well.

The powder through die was a pain, I adjusted it by the manual and it kept flaring too much causing the cases to bend/split/disfigure. But I was finally able to adjust it by experimenting and get it working.

I couldnt get the seating die to work, it would seat a little and then try to crimp but thats probably because I see from the above post that I was using hte factory crimp die instead of the seating die. I am going to go try the seating die out now.

I will let you know how it turns out, and call lee tommorrow for some insite on the indexing issues.
jclayto is offline  
 
Page generated in 0.03989 seconds with 8 queries