Thread: S&W 14-3
View Single Post
Old September 16, 2012, 05:15 PM   #3
JC57
Senior Member
 
Join Date: September 2, 2010
Posts: 375
Sounds like if your cylinder yoke is sliding forward, you may be missing the yoke screw:

http://www.gunpartscorp.com/catalog/...90&catid=10027

Or else it's just not tightened up enough.

Take a look on the right side of the gun just above the trigger. Is there an empty screw hole there? If so, you're missing your yoke screw.
JC57 is offline  
 
Page generated in 0.03192 seconds with 8 queries