View Single Post
Old November 17, 2012, 03:12 PM   #1
SEHunter
Senior Member
 
Join Date: October 6, 2009
Posts: 332
Redding Competetion Shell Holders

Do these do a good job at allowing you to adjust for head space without having to adjust the die by trial and error each time?

Besides the obvious, how do they work? Once you determine which measurement of shell holder you need for a particular cartridge/gun, do you simply screw the die down until it touches the shell holder/ram at the raised position every time? If so, this seems to potentially save alot of time as well as provide more consistancy with each sit down at the press.

Any feedback with experience using these is appreciated.
SEHunter is offline  
 
Page generated in 0.02150 seconds with 8 queries