The Firing Line Forums - View Single Post

+1k ammo · June 10, 2013, 06:12 AM

Thanks. I do want to do it correctly so the screw method is probsbly out. I had a hard time removing last screw of the red dot frame and had to tap in a new head cause was stripping.
Anyway, since it is a nice gun i will get estimate from my local gunshop who i trust vs sending to SA.
I will for sure do the sites but will see about welding holes or even replacing frame.
But at moment ill get sites on it and the holes wont hurt anything. I am new to welding,mig, but that looks so small even fir tig. But i am not a gunsmith!

June 10, 2013, 06:12 AM	#8
+1k ammo Senior Member Join Date: January 9, 2013 Posts: 235	Thanks. I do want to do it correctly so the screw method is probsbly out. I had a hard time removing last screw of the red dot frame and had to tap in a new head cause was stripping. Anyway, since it is a nice gun i will get estimate from my local gunshop who i trust vs sending to SA. I will for sure do the sites but will see about welding holes or even replacing frame. But at moment ill get sites on it and the holes wont hurt anything. I am new to welding,mig, but that looks so small even fir tig. But i am not a gunsmith!