|
That's pretty much what I did. I made a frame 4 x 4 feet out of 1 x 6 boards, and then nailed 1 x 2 all the way around the outside, about 2 inches from the bottom of that frame, which has been covered with 1/4 inch galvanized hardware cloth on the bottom. The inside dimension of the lower part is about 1/4 inch larger than the outside dimension of the top frame so the top will fit inside the bottom portion and the 1 x 2 holds the top on the edge of the bottom.
I simply drop brass and media into the top frame, shake it a bit to get the media out of the brass, then tip the top over and pour the brass out. Simple and very useful. I can screen about 2,000 7.62 cases at a time although it's easier to shake if I only put 1,000 or so in the top.
|