Actually, you may even be able to use the 9mm decapper if you can screw the decapping pin down far enough to reach the .38 spcl primer. I didn't test it, but it looks like my RCBS decapper has enough length to do that.
Going against intuition, the 9mm die has a slightly larger ID than the .38 spcl even though 9mm bullets are usually a few thou less in diameter. So I wouldn't load anything but light "plinking" loads. You won't get as tight a taper crimp as you would with a .38/.357 TC die. Therefore setback becomes more of an issue.
|