View Single Post
Old June 3, 2011, 01:10 AM   #13
Nosparetime
Senior Member
 
Join Date: July 6, 2009
Location: Oregon
Posts: 100
I don't see any cases in that picture I would not load. I have a taper punch on my bench that i would take most of those dents out with. (I love salvaging brass that others would throw away) You probably need to remove the crimp the first time you load them.

There are a lot of ways to do that. My Dillon 1050 has a station that does that for me when i have it set up.

Dillon's super swager is one of the best separate tools I have used. But I have done them with the hand tools from RCBS and others. I chuck the bit in a drill.
Nosparetime is offline  
 
Page generated in 0.03476 seconds with 8 queries