View Single Post
Old May 19, 2012, 11:03 AM   #9
zxcvbob
Senior Member
 
Join Date: December 20, 2007
Location: S.E. Minnesota
Posts: 4,295
How cleanly do you really need to machine it if you cut the bevel out of the mold? I was thinking just kiss it with a countersink bit and clean it up with a pocket knife. (Aluminum Lee molds)

As long as the imperfections in the former-bevel are oversize, won't the sizing die clean them up? Or will it affect cutting the sprue and mess up the base?
__________________
"The only way to stop a bad guy with a gun is with a good guy with a gun"
zxcvbob is offline  
 
Page generated in 0.03326 seconds with 8 queries