View Single Post
Old September 14, 2020, 12:04 PM   #3
burbank_jung
Senior Member
 
Join Date: December 5, 2019
Posts: 620
2 piece mold

I've seen images of the two piece molds and how the parts are suppose to be epoxied together. The most common methods I've read of are the hollow points and the softening the tip by submerging the base and shank in cold water and softening the tip with a propane torch. I think a pure lead buckshot at the tip and encased at the base with an alloyed lead/ GC would act like a softnose or like a paper patched bullet. It's something on my "want-to-do" list.
burbank_jung is offline  
 
Page generated in 0.03031 seconds with 8 queries