I wouldn't use a Dremel on that. The problem is the gap and making it bigger won't help.
Can you flip the measuring drum or otherwise set it up so that the clean edge trails when you are moving it to dump powde? It's okay to cut a few grains of stick powder. A chip missing from the drum on the trailing edge can form a small pocket where power can wedge between the drum and body.
If you use a Dremel, use it to open up the cavity leaving the top edges sharp and square.
__________________
Proud member of the NRA and Texas State Rifle Association. Registered and active voter.
Last edited by Sport45; March 11, 2013 at 10:22 PM.
|