View Single Post
Old January 10, 2019, 10:58 PM   #8
LineStretcher
Senior Member
 
Join Date: June 14, 2018
Posts: 466
The Talley rail came in today, they had it in stock but didn't list it on their website. I cleaned up the bedding job and added a little where it was needed and then put the rail on, lapped the rings and mounted the scope. It's dialed in and ready for the range.

I put a Vortex PST 5-25 on it. The rings are Seekins. Vortex PST scope tubes are exactly 30mm so you have to lap the rings or the scope will not fit properly. I found this problem with Warne and Leupold rings also. All my other scopes are just slightly under stated tube diameter. I kind of like that Vortex does this. It forces you to lap your rings and you end up with a perfect fit.
Attached Images
File Type: jpg TRR Scoped1.jpg (227.9 KB, 16 views)
LineStretcher is online now  
 
Page generated in 0.03060 seconds with 9 queries