It'd be a major project.
Frame is wrong for the center fire hammer.
You might be able to convert the hammer to a transfer or transfer firing pin system. Might be able to reshape the existing hammer and just install a transfer firing pin in the frame.
Cylinder is wrong. Take some fairly major machine work to turn it into a cartridge cylinder. If it can be done at all.
In the end, you will have a cap and ball version of a cartridge revolver which was converted back to cartridges.
I owned two such revolvers. One was Uberti 5.5 inch barrel and the other was Pietta 9 inch barrel. I liked them both but came to the conclusion that the design embodied too many philosophical compromises. In the last ten years I have sold a total of three revolvers. The two cap and ball Cattlemans are two of the three I have let go.
__________________
Seek truth. Relax. Take a breath.
|