Well I finished the front grip strap and decided to also stipple the lower part of the trigger guard. I took the advice of another poster who uses a file to make the stippling. I have a 12" round bastard and half round bastard. Every time I strike the surface with them they cover about a 1/8" square patch with stipples. Instead of 3 hours and 50,000 hammer strikes, this took about an hour with about 5,000 strikes....and this surface is wider and I also did the lower part of the trigger guard. I even went back to the rear grip strap and went over it a couple of hundred times to get it to match the front. It really turned out great. Feels like skateboard tape, without the problems of the tape wearing or coming off.