View Single Post
Old November 16, 2012, 04:01 PM   #4
FrankenMauser
Senior Member
 
Join Date: August 25, 2008
Location: Potatoes and Hops
Posts: 10,994
First step with a new Lee mold: check alignment and deburr.
Second step: face the top of the mated blocks and the sprue plate with emery cloth on a piece of glass.

Third: cast with it, so you can figure out what else is wrong.

I haven't lapped one yet, but I do have a mold that would probably benefit from it.
__________________
Don't even try it. It's even worse than the internet would lead you to believe.
FrankenMauser is online now  
 
Page generated in 0.04770 seconds with 8 queries