View Single Post
Old November 28, 2010, 08:55 PM   #64
Join Date: September 29, 2010
Location: Bay Area, California
Posts: 60
Back to topic.

Great notes on cleaning, but I see it this way.

I clean without disassembling the frame of my Pietta 1850 Remington. Take the cylinder out, into hot soapy water, clean the frame best I can with hot, soapy water and a Q-tip, swap the barrel with soapy water on a patch, , run a bronze brush, run some dry patches, run lightly oiled patch, one more dry patch. Dry well with hair dryer, light coat of oil, back in the storage case.

These pistols are available new for less than $200, and I figure the time I save cleaning in detail is time I can spend shooting. And then buy a new pistol a year or two down the road.

Of course I shoot for fun. If you are shooting for competition, clean VERY well.

Last edited by jolasa; November 28, 2010 at 10:30 PM.
jolasa is offline  
Page generated in 0.03023 seconds with 8 queries