Quote:
I have a NEI mold for 45 cal 225 gr. SWC which has a beveled base.
|
The only real answer is to
never buy another bevel base mold!(
SINCE WE'RE SEVERELY LIMITED IN OUR SMILLY SELECTION, I'LL SAY OF COURSE, I WAS JOKING.)
You're stuck with it unless you can have a machinist remove the bevel base part of the mold. The suggestion made by ICH is real simple. With the lube die and top punch installed, but no boolit, just put a Styrofoam meat tray, egg carton, or other thin plastic foam in the lubber, lower the ram and punch a disc. This will conform to the bottom of the boolit and seal the bevel so the lube can't get under it.