|
No,im not planning on performing this illegal conversion.im just trying to get enough information to end an arguement with one of those know it all poeple i work with.He says all thats required to convert a new bushmaster lower to a functional m16 is all the m16 fire control parts and bolt carrier.and all the machining thats required is to drill the autosear pin hole above the selector switch,but from my understanding you would also have to mill out some of the reciever to allow room for the autosear since the xm15 recievers are not fully milled like the m16 recievers are.i know it still wouldnt be that hard just remove a little bit of the reciever on each side,but whos right about this me or him.thanks alot:kentucky joe
|