Quote:
|
Originally Posted by slammedsi
mehavey, That is exactly right. Its while loading another round into the chamber, that it gets jammed. Not allowing the slide to fully close on the next round.
|
The finished round may be rubbing the chamber at the case neck (not enough taper crimp) or the case base (not enough full-length sizing).
Drop a resized case (no bullet) in the chamber. If it does not drop in freely, the case is not being fully sized - adjust your resizing die until the case drops in freely.
If the resized case drops in the chamber freely but the finished round does not, then the case neck after the bullet is seated may be rubbing the chamber. Apply enough taper crimp until the finished round drops in freely (for tighter barrels, you may need .469"-.470" taper crimp).