View Single Post
Old November 5, 2014, 12:42 PM   #18
RickB
Senior Member
 
Join Date: March 1, 2000
Location: Boise, ID
Posts: 8,511
Quote:
10mm is pretty sweet. I have a glock 20 (gen2?) which I blew the mag catch in half using reloads I bought at the range. Poor chamber support, be careful what you feed your glock!
I was resizing 10mm cases last night, and among them were cases from Double Tap, purveyors of factory "nuclear" ammo, and those cases, fired in a Glock (characteristic firing pin marks) were quite visibly bulged.
When I've seen bulged cases from a Delta Elite, the bulge is just ahead of the extractor groove where the case is unsupported, but the cases I was handling last night were bulged along the entire lower half, as if the chamber diameter is too large.
I won't be pushing the pressures when reloading these cases!
RickB is offline  
 
Page generated in 0.02276 seconds with 8 queries