The Firing Line Forums - View Single Post - Buffalo brothers grips for my taylor's ranch hand

Hawg · January 25, 2017, 10:39 PM

You will need to fit the center piece as well as the grips. Put a panel on the frame and take a sharp pencil and trace around the frame. Sand it down til the pencil line disappears. You can tape the frame and do final sanding on the frame but be careful not to sand through the tape. Just go slow and don't use a dremel.

January 25, 2017, 10:39 PM	#2
Hawg Senior Member Join Date: September 8, 2007 Location: Mississippi Posts: 16,190	You will need to fit the center piece as well as the grips. Put a panel on the frame and take a sharp pencil and trace around the frame. Sand it down til the pencil line disappears. You can tape the frame and do final sanding on the frame but be careful not to sand through the tape. Just go slow and don't use a dremel.