The Firing Line Forums - View Single Post

Johnny Guest · January 18, 2001, 09:26 PM

Intel6--

Your post above concerning loading for .25 and .32 ACP is of interest to me. I thought I was about the only one who loaded for the mouse guns. I haven't in a lot of years, though, and have lost my load notes. I feel the state of the art MUST have advanced in the meanwhile. I have dies and a limited selection of bullets on hand.

I would appreciate your sharing load information, including velocities obtained, on these two cartridges with me. If you're loading way over published data, please respond by e-mail. ([email protected]) If you're not going over the edge, you might want to start a new topic area in this forum.

Thanks and best regards,
Johnny
MOLON LABE!

January 18, 2001, 09:26 PM	#18
Johnny Guest Moderator in Memoriam Join Date: August 28, 1999 Location: North Texas Posts: 4,123	Itty Bitty Cartridges Intel6-- Your post above concerning loading for .25 and .32 ACP is of interest to me. I thought I was about the only one who loaded for the mouse guns. I haven't in a lot of years, though, and have lost my load notes. I feel the state of the art MUST have advanced in the meanwhile. I have dies and a limited selection of bullets on hand. I would appreciate your sharing load information, including velocities obtained, on these two cartridges with me. If you're loading way over published data, please respond by e-mail. ([email protected]) If you're not going over the edge, you might want to start a new topic area in this forum. Thanks and best regards, Johnny MOLON LABE!