The Firing Line Forums - View Single Post

DaMan · August 24, 2000, 10:40 AM

I've seen where it was done. It IS possible, but not practical.

The .223 case is sized with the .380ACP sizing die, trimmed to length, and then reamed to an internal dimension of .351".

I'd just stock up on some commecial .380 cases! MUCH easier! ;-)

Regards! DaMan

[This message has been edited by DaMan (edited August 31, 2000).]

August 24, 2000, 10:40 AM	#3
DaMan Senior Member Join Date: July 16, 2000 Posts: 222	I've seen where it was done. It IS possible, but not practical. The .223 case is sized with the .380ACP sizing die, trimmed to length, and then reamed to an internal dimension of .351". I'd just stock up on some commecial .380 cases! MUCH easier! ;-) Regards! DaMan [This message has been edited by DaMan (edited August 31, 2000).]