View Single Post
Old August 19, 1999, 08:20 PM   #1
Brett Bellmore
Senior Member
 
Join Date: March 17, 1999
Location: Capac, MI, USA
Posts: 1,927
I'm a somewhat experienced machinist/designer, (More on the design than the machine, as it happens.) and I'm looking at setting up a corner of my basement, about 10 by 10 feet, as a shop, to do gunsmithing and other light machine work. I've seen advertisements for the "Smithy" combination lathe/milling machine, and have even been to their factory a couple hours drive from here, to look at the product. But I don't know anyone who's actually USED one of these machines. Are they any good? (The specific model I'm looking at is the CB-1239) If not, what would you recomend, keeping in mind the limited space?
Brett Bellmore is offline  
 
Page generated in 0.02688 seconds with 8 queries