Thread: stippling
View Single Post
Old March 18, 2000, 01:29 AM   #5
EQUALIZER
Senior Member
 
Join Date: September 12, 1999
Posts: 657
Some of the links that I got in the handguns section looked like a vibratory engraver was used. Is there a preference as to hammer/chissel vs. this type engraver, George? It seems like I can get some good control in scrap alluminum w/one. Haven't seen enough to compare the difference in asthetics though.

------------------
"But now, he that hath a purse, let him take it, and likewise his scrip; and he that hath no sword, let him sell his garment, and buy one." -Jesus Christ (Luke 22:36, see John 3:15-18)

EQUALIZER is offline  
 
Page generated in 0.02747 seconds with 8 queries