View Single Post
Old August 26, 2012, 09:33 PM   #7
crowbeaner
Senior Member
 
Join Date: June 4, 2007
Location: Upstate SC
Posts: 1,943
I run all my LC 223 brass through an RCBS sb die and then uniform the flash holes. then I get the same amount of swage on each case. I can run them through the RCBS swager almost as fast as the Dillon somebody stole. Clean the primer pockets to remove the ash and any brass left over from the flash hole tool, and they're good to go.
crowbeaner is offline  
 
Page generated in 0.03878 seconds with 8 queries