View Single Post
Old August 22, 2010, 08:23 AM   #2
denster
Senior Member
 
Join Date: April 24, 2010
Location: Ohio
Posts: 581
I don't see why anyone would consider using a screw type ball puller on a revolver.
For balls in the cyllinder a short length of brass rod through the nipple hole works fine. For balls in the barrel a length of hardwood dowel or a brass or nylon rod will bump it out easily.
A screw type puller takes quite a bit of effort and in the barrel generally two people to use. The screw going in expands the ball and makes it an even tighter fit and harder to remove.
denster is offline  
 
Page generated in 0.03593 seconds with 8 queries