The Firing Line Forums - View Single Post

Dal052181 · September 12, 2012, 08:21 PM

So I had my trigger group out of my Chinese Sks Monday to install the sear my buddy cleaned up for me and this is the issue I'm having now. when I reinstalled the sear, mag release and spring followed by the pin I was checking the operation holding it in my hand and when I pressed on the disconnector it was very stiff, no movement. I pressed a little harder and the hammer flew forward. I asked my buddy what he did and he said all he did was take light sand paper to the sear to smooth out the surface to help with the trigger pull. I let him do it because it made his trigger feel pretty smooth. Well I thought maybe he screwed up so I bought a brand new unissued sear and installed. Same problem. Did I do something on the reinstall or what? Please help!

September 12, 2012, 08:21 PM	#1
Dal052181 Junior Member Join Date: September 7, 2012 Posts: 5	Umm.. My Sks trigger group is unsafe! So I had my trigger group out of my Chinese Sks Monday to install the sear my buddy cleaned up for me and this is the issue I'm having now. when I reinstalled the sear, mag release and spring followed by the pin I was checking the operation holding it in my hand and when I pressed on the disconnector it was very stiff, no movement. I pressed a little harder and the hammer flew forward. I asked my buddy what he did and he said all he did was take light sand paper to the sear to smooth out the surface to help with the trigger pull. I let him do it because it made his trigger feel pretty smooth. Well I thought maybe he screwed up so I bought a brand new unissued sear and installed. Same problem. Did I do something on the reinstall or what? Please help!